- All products are added to your cart.
Sticker set for Volkswagen Transporter T4 T5 T6
Dimensions: 1 x Decal sheet (dimensions can be found in the sketch)
Gluing position: Driver- and Passenger side, Rear and Front from the outside
Scope of delivery:
1 x Decal sheet (dimensions can be found in the sketch)
1 x Application / transfer film (per vehicle side / decal sheet attached to the sticker)
1 x Free 3M squeegee with felt edge
1 x Cutter knife
1 x Application instructions
- This article is produced individually for you.
- Due to the wafer-thin film, the sticker looks like it has been painted.
- With transfer film: After bonding, simply remove the transfer film.
The following applies to all vehicle stickers:
- All motifs can be cleaned and washed.
- Before sticking on, make sure that the surface is clean and free of dust and grease.
- The paint should be in perfect condition.
Technical characteristics of the Oracal 751C film series
With a material thickness of just 0.06 mm, the color foils in the series are very flat and ideally nestle on straight and curved surfaces. A silicone-coated carrier paper enables processing on all common cutting plotters and facilitates weeding even the smallest of fonts and designs. After bonding, the Oracal 751C PVC film shows a maximum shrinkage of only 0.15 mm in the longitudinal direction. Depending on the selected color, the labeling film has a maximum durability of between 3 and 8 years when used outdoors. If the film is used indoors, the durability is almost unlimited. Oracal 751C labeling foils are flame retardant according to DIN EN 13501-1 and resistant to oils, fats as well as weak salts, alkalis and acids. A temperature resistance is given in the range from -50 ° C to + 120 ° C. The high-performance adhesive films are also largely resistant to seawater.
Instructions for processing Oracal 751C color foils
The ambient temperature should not fall below + 15 ° C when bonding Oracal 751C High Performance Cast films. Temperatures in the range of + 18 ° C and + 22 ° C are ideal. After bonding, major temperature fluctuations should be avoided for about 72 hours. You can choose between wet and dry application for Oracal 751C films. For transferring to the surface to be glued, which must be free of dust, grease and dirt, papers and foil tapes with medium to high adhesive strength are suitable. Make sure that you use an appropriate transfer paper for wet application. Oracal 751C films can be stored for about 2 years. After that, the optimal adhesion of the adhesive can no longer be guaranteed.